If the walls have plaster, you should use a reciprocating saw instead of a drywall saw.Do not go deeper than half an inch with the saw to avoid damaging the studs. Start with cutting it into small pieces with the drywall saw.Repeat until all the surrounding tiles are removed.Remove the tiles by prying off with the help of a putty knife.Use a utility knife to dig through the grout or the plaster. From about eight inches apart, remove the tile plaster.Step 5: Separating TilesĪt this stage, you have to separate the tiles that surround the tub. Remember to turn the nuts counterclockwise. Use a wrench to disconnect the pipes from the panel. When you find the access panel, you will see that the main and overflow pipes of the tub are attached to the panel.You may need to cut across the wallboard to have access to the panel. If your bathroom is on the ground floor, you will find the panel in the basement ceiling. It can be behind the tub on the other side of the wall. Now you locate the panel that gives access to the tub’s main and overflow pipes.You will find them on the face of the cover or underneath the faceplate. To take out the cover of the overflow drain, find the screws first.If it seems stuck, twist it counterclockwise and then pull.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |